Starting The Unit; Raising And Lowering The Mast - Generac Power Systems MLT4060M Owner's Manual

Starting the Unit

DANGER
Electrocution. DO NOT use the unit if
electrical cord is cut or worn through. Doing
so will result in death or serious injury.
WARNING
CAUTION
Equipment damage. Do not attempt to start or operate
a unit in need of repair or scheduled maintenance.
Doing so could result in serious injury, death, or
equipment failure or damage.
Owner's Manual for MLT Light Tower

Raising and Lowering the Mast

Lightning strikes can kill or cause severe injury
even if you are not touching the unit.
(000263a)
> 60 mph > 60 mph
(000291)
Personal injury or equipment damage. Do not raise
or lower the mast while the unit is operating.
Doing so can break the lenses and cause the
lamps to shatter.
Personal Injury. Stop immediately if the mast hangs
up or the winch cable develops slack. Excess slack
could cause the mast to collapse, resulting in personal
injury or equipment damage.
Tipping hazard. Extend the outriggers and level the unit
before raising the mast. Keep the outriggers extended while
the mast is up. Failure to do so could cause the unit to tip
and fall and could result in death or serious injury.
Burn hazard. Lamps become extremely hot
while in use. Allow 10–15 minutes for cooling
before handling or lowering mast. Touching a
hot lens or fixture can cause severe burns.
•
Keep area around the unit clear of people while
raising and lowering the mast.
•
ALWAYS lower the mast when not in use.
•
The tower extends up to 30 ft (9.14 m). Make sure
area above trailer is open and clear of overhead
wires and obstructions.
•
If for any reason any part of mast hangs up or
winch cable develops slack while raising or
lowering tower, STOP immediately! Contact a
Generac Mobile Products Authorized Service
Dealer.
•
NEVER remove safety pin or pull mast locking pin
while tower is up.
Introduction and Safety
WARNING
Electrocution. Do not set up or operate
this unit if severe weather is expected.
WARNING
Do not set up the unit if high winds
are expected. High winds can cause the
unit to tip or fall, causing severe injury
or machine damage.
WARNING
WARNING
WARNING
WARNING
(000296)
(000297)
(000279)
(000265)
(000266)
(000278)
5