Table of Contents
Advertisement
Troubleshooting
No Light
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect three potential problem areas: the power supply, the lamp, the fuse.
1. Power supply. Check that the unit is plugged into an appropriate power supply.
2. The lamp. Replace the old lamp with a new one with the same specifications. See page 7 for
replacing lamps.
3. The fuse. Replace the fuse. See page 10 for replacing the fuse.
Product Specification
Model: Showtec Inferno
Voltage: 240V-50Hz (CE)
Fuse: F1A / 250V
Dimensions: 340x350x280mm (LxWxH)
Weight: 3,45 kg
Lamp
Allowed lamp models*:
Philips EFP GZ6.35 12V 100W (50 hr, 750 Lumen) ordercode 80810
Osram EFP GZ6.35 12V 100W (50 hr, 750 Lumen) ordercode 80810O
Sylvania EFP GZ6.35 12V 100W (50 hr, 550 Lumen) ordercode 80810S
Showtec EFP GZ6.35 12V 100W (50 hr) ordercode 82399
Showtec EFP GZ6.35 12V 100W (50 hr,) ordercode 82403
Electro-mechanical effects
Max. ambient temperature t
: 55°C;
a
Max. housing temperature t
: 80°C
B
Cooling: 1 axial fan in the projector
Minimum distance:
Minimum distance from flammable surfaces: 0.5m
Minimum distance to lighted object: 1.3m
*: Versions for other lamps may be produced. Please check the specification label on your product.
Design and product specifications are subject to change without prior notice.
Website:
www.Showtec.info
Email:
service@highlite.nl
11
Advertisement
Table of Contents
