Power loss at PSU 2
To activate the warning on the device:
1. Open the power tab in the STATE section.
2. Toggle the switch Redundancy to On.
The warning signals only the current state.
To activate the warning on the web remote:
1. In the STATE section, activate the toggle next to Power Loss Warning.
See also: Section 8.5.2, "Web Remote"
8.2. Presets
Any change in the device configuration is persistent. After a power loss, the device will revert back to its
last state. Additionally, the M-32 AD Pro can save fifteen states in presets numbered 1-15. After a
preset is loaded, any change in the configuration will result in an unsaved changes state.
Representation of an unsaved preset on the device.
The internal preset storage is not affected when the device firmware is updated.
Moreover, recalling the factory default preset does not delete any other saved preset.
Settings that are not saved in a Preset
The following settings are not saved in a preset:
• Auto-lock
• Lock code
• Remote control
8.2.1. Saving Presets
Up to 15 presets can be saved in the internal storage of the M-32 AD Pro.
To save a preset on the device:
1. Open the preset tab in the STATE section. The cursor will highlight a preset number.
RME M-32 AD Pro User's Guide
8.2. Presets | 24