Advertisement

Quick Links

Certification Exhibit
FCC ID: SK9ACT1
IC: 864G-ACT1
FCC Rule Part: 15.247
IC Radio Standards Specification: RSS-247
ACS Project Number: 16-0130
Manufacturer: Itron, Inc.
Model: ACT1
Manual
5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACT1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ITRON ACT1

  • Page 1 Certification Exhibit FCC ID: SK9ACT1 IC: 864G-ACT1 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-247 ACS Project Number: 16-0130 Manufacturer: Itron, Inc. Model: ACT1 Manual 5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598...
  • Page 2: Meter Module

    ACT1 Meter Module Technical Reference Guide Effective Date: July, 2016 ACT1 Meter Module...
  • Page 3: Revision History

    Revision History The following table describes the changes to this document for each revision of the ACT1 meter module: Revision Date Description of Change July, 2016 Initial Release ACT1 Meter Module...
  • Page 4: Regulatory Compliance

    • Consult the dealer or an experienced radio/TV technician for help. • Changes or modifications to this device not expressly approved by Itron, Inc. could void the user’s authority to operate the equipment. Innovation, Science and Economic Development Canada (ISED) This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
  • Page 5: Recycling Information

    General Description The Itron ACT1 is an electricity metering module which includes a 902.4 MHz to 927.6 MHz transmitter as well as WiFi. The module operates on AC as well as DC voltage which is supplied by a host device.
  • Page 6: Installation

    Installation The ACT1 module will be installed in the Itron OPENWAY RIVA CENTRON electric meter. Shown are the meter base with metrology board, the board to board connector, the ACT1 module, the display and the inner and outer cover. ACT1 Meter Module...
  • Page 7 Install the display on the ACT1 module by pushing metal pins of display into module connector. ACT1 Meter Module...
  • Page 8 Insert module into upper section of inner cover and connect two wired connectors to module. ACT1 Meter Module...
  • Page 9 Connect metrology and the ACT1 module using the board to board connector. ACT1 Meter Module...
  • Page 10 Install lower inner cover. ACT1 Meter Module...
  • Page 11 Install outer cover. ACT1 Meter Module...

Table of Contents