Table of Contents
Advertisement
SMART CABLE STATUS LIGHTS
STATUS
Detecting
Ready to start
Low Voltage
High Voltage
Short Circuit
Reverse Polarity
Reverse Charge
Over heating
No operation within 30 seconds of connecting
to the battery terminals
JUMPSTART THE VEHICLE BATTERY
CAUTION: MAKE SURE THAT THE POWER PACK IS AT LEAST 60% CHARGED
(3 POWER INDICATOR LIGHTS ARE LIT) BEFORE YOU ATTEMPT TO
JUMPSTART.
ALWAYS carry out the following preliminary checks:
• Switch off the vehicle ignition and ALL ancillary equipment (lighting,
radio etc.)
• Ensure the vehicle battery is rated at 12V and is not damaged in any
way.
• Ensure the area is well ventilated.
• Make sure that the device is at least 60% charged (3 power indicator
lights are lit).
NOTE: This device will not jumpstart a vehicle if the battery is very low or
completely flat.
1. Switch the ignition to 'start' for NO MORE than 6 seconds. If the engine does
not start within this time, SWITCH OFF the ignition and wait for at least 3
minutes before trying again.
2. Once the engine is running, disconnect the clamps within 30 seconds,
BLACK clamp FIRST, then disconnect the RED clamp.
3. Leave the vehicle engine running for a while to let the alternator recharge
the battery.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Green LED
Flashing
Solid
Off
Off
Off
Off
Solid
Off
Solid
10
Red LED
Beeping
Flashing
No
Off
No
Solid
No
Solid
No
Flashing
Yes
Flashing
Yes
Solid
Yes
Solid
Yes
Solid
No
Advertisement
Table of Contents
