Advertisement
（2）單動模式
在此模式下，每按一次，動作都不會連續被觸
發，用以確認機構間的相對位置。
依照下列順序進行：
A. 將 " 電源開關① " 切至 OFF。
B. 將 " 切換鍵 ② "，切換至「手動」側。
C. 按住 " 停止鍵③ " 不放，將 " 電源開關① " 切
到ＯＮ，" 停止鍵③ " 按 3 秒後放開。
D. 按下 " 準備鍵④ "，壓腳裝置回到原點。
E. 按下 " 再送帶鍵⑤ "，送出一個褲耳料帶。
G. 按下 " 起動鍵⑥ "，進行下個動作。
H. 動作最終後，若要再反覆時，由 E 開始。
④
(2) Manul mode
Under this mode, all operation are single action
for every time switch are pressed. This is to
check all mechanical mechanism are in the
correct relative position.
Proceed with the following:
A. Switch '' ① power'' to OFF.
B. Shift the "switch button ② " to manual.
C. Press and hold the "stop ③ " button while
press the ''power switch ① toon hold the stop
button for about 3 seconds then release.
D. Press "ready ④ " button to set the foot back
to original position.
E. Press ''Feed-again ⑤ " to feed a loop.
G. Press "start ⑥ " for the next action.
H. Start from step E to repeat above process.
②
③
⑥
10
18
Introduction
⑤
①
P16
Advertisement
