Advertisement
①
B. 限位架調整
褲 耳 碰 到 支 撐 板 ④ 的 側 面， 鬆 開 固 定 螺 絲
②、③，進行限位架⑤、⑥調整。
③
⑤
C. 褲耳位置調整
送褲耳⑦後，在壓腳⑧下，褲耳寬中心和壓
腳中心（刻痕）需一致，鬆開固定螺絲⑨，
轉動旋鈕⑩，調整左右位置，鬆開固定螺絲
⑫可調整⑬擋邊前後位置。
（刻度板⑪可檢視移動距離）
擋邊與褲耳切刀位置調整至一直線時，即為
褲邊邊線與褲耳邊線等高的位置。
B. Limit support rack adjustment
⑥
C.Loop position adjustment
Introduction
When loop touch the side of the limit
support rack ④ loosen the screw ②、③ to
proceed adjustment on ⑤、⑥ .
②
④
After loop delivered ⑦ to presser foot ⑧ lift,
the center of loop and foot lifter need to be
align (Cut line).
Adjust the left and right position by loosen
the screw ⑨ and tuning knob ⑩ use the
scale plate ⑪ to measure the adjustment.
Adjust the front and back position by loosen
the screw ⑫ , and trimmed hamper ⑬ .
Adjust the position of loop and trimmed
hamper to alignment, the edge of waistband
will be the same height as the edge of loop.
P8
Advertisement
