Table of Contents
Advertisement
D-Link DVG-3004S User Manual
2. How to Setup and connect basically
2.1 System Requirement
1. One PC (a) Pentium 100 or above, 64 RAM, Windows 98 or above.
(b) Ethernet card or COM port
2. One standard straightforward RS-232 cable (female connector to Gateway
side).
3. PBX extension Lines or PSTN Lines.
4. Software tools (a) Hyper Terminal, TELNET, Web Browser.
2.2 IP Environment Setting
User must prepare a valid IP address, complied with IP Network, for Gateway's
proper operation.
For testing the validation of chosen IP address, using the same IP
configuration in other PC or Notebook, and then try to connect to Public
Internet (go to well-known website, receive Internet mail, or ping a specific
public IP address). If it works, use the same IP address and network
configuration for Gateway.
Please follow up the step for the configuration of your computer or notebook.
2.2.1 For Windows 2000/NT
Please make sure that the network interface of your computer is working fine
and the
cross over line
you could use a
hub
your computer and configure the network parameter as follow:
1
Go to the start menu and enter the setting area. Click control panel.
2
Enter the network configuration.
(b) Gatekeeper (optional).
(RJ-45) is connecting with the computer correctly or
to connect with your computer and this gateway. Turn on
9
Advertisement
Table of Contents
