Table of Contents
Advertisement
Section - Command Line Interface
Warning: On executing the following NTP server commands the system will assume that the time configuration should
be obtained from the NTP server and the time configuration will be set to 'NTP server' if it is in manual mode currently.
If you do not want this to happen, please undo the change through the web page.
Set Primary NTP Server Command:
Command Name:
Command description:
Command Format:
Example:
Set Secondary NTP Server Command:
Command Name:
Command description:
Command Format:
Example:
Warning: Using the following commands to configure the system time will result in the time configuration mode being
set to manual. If you do not want this to happen, please undo the change through the web page.
Set Zone Command:
Command Name:
Command description:
Command Format:
Example:
D-Link DVX-1000 User Manual
set primaryntpserver
The 'set primaryntpserver' command configures the primary NTP server address.
It will automatically sync the time with the NTP server.
set primaryntpserver <domain/ipaddress>
set primaryntpserver pool.ntp.org
set secondaryntpserver
The 'set secondaryntpserver' command configures the secondary NTP server
address. It will automatically sync the time with the NTP server if not already sync
with the primary NTP server.
set secondaryntpserver <domain/ipaddress>
set secondaryntpserver 192.168.10.10
set zone
The 'set zone' command sets the system time zone. Use 'set zone ?' to get zone
numbers.
set zone <zone number>
set zone 4 to set pacific time zone
Advertisement
Table of Contents
