Gabarron SH6M Installation Instructions And User Manual page 8

5.- Fix the heater to the wall. Please note the weight of the heater is taken by the feet, the wall fixing screws are only to
prevent the heater overturning. If there is any doubt as to the strength of the wall, please consult an expert. Storage
heaters are very heavy and the installer must ensure that they are securely fixed and that there is no
possibility of them overturning.
6.- Connect the heater using the enclosed wiring diagram. Ensure that all connections are firm. Do not leave any remaining
wire inside the heater.
7.- Remove the inner front panel.
Warning!
At the other side of this front panel there is a breakable thermal insulation panel. Both sides must be handled with care. Avoid
touching the insulation.
8.- Do not disconnect the electrical elements. Remove the packaging then lift and recline the elements.
9.- Place the storage bricks carefully, with the flat side facing the back of the heater. Arrange two rows of bricks (fig 3). Should
big bricks (ref 11072) are required they must be placed at the right side.
fig 3
10.- Fix the elements in their original position. Place the other two rows of bricks with the knobs face to face.
fig 4
11.- Refit the inner front panel. If the bricks have been fitted correctly, you will find no difficulty in refitting the panel (fig 4).
12.- Attach the front panel and fix it at the bottom edge with the two screws provided.
8