Operation; Preparation Before First Use; Do A Check On The Appliance; Prepare The Appliance - Bellfires Room Divider Medium 3 CF User Manual

Operation

4 4 Operation
4.1

Preparation before first use

4.1.1

Do a check on the appliance

1.
2.
3.
4.1.2

Prepare the appliance

1.
2.
3.
4.
5.
4.1.3

Connect the receiver with the remote control

1.
2.
4.1.4

Start the appliance

14
Make sure that the appliance is not damaged.
Make sure that the glass is not damaged.
Make sure that the pilot light operates correctly.
Warning:
• Do not use the appliance for 4 weeks after installation. This time is
necessary for the building materials to set.
• Make sure that there is sufficient ventilation in the room in which the
appliance is installed.
Note: The appliance has a heat-resistant coating. When you use the
appliance for the first time, the coating can cause an unpleasant, but harmless
smell.
Start the appliance, refer to section
Set the flame height to maximum, refer to
Keep the flame height to maximum for 10 minutes to make sure the chimney
becomes warm.
Use the appliance with maximum flame height for several hours to remove the smell
of the coating.
When the appliance is cool, clean the appliance. Refer to
Note:
• You only have to connect the receiver once. Even when you change the
batteries, the remote control stores the settings.
On the receiver, push and hold the reset button until you hear two beeps.
Within 20 seconds of the second beep, push and hold the down button on the remote
control until you hear two short beeps. If you hear one long beep the receiver is not
set, try again.
The receiver is connected.
Warning:
• Keep a minimum distance of 100 cm of the appliance when you start the
pilot light.
• When the pilot light goes out, always wait 5 minutes before you start it
again.
4.3
.
4.3
.
5.2
.
Room divider Medium 3