Troubleshooting; Troubleshooting Table; Troubleshooting Procedures; Replace The Batteries Of The Remote Control - Bellfires Room Divider Medium 3 CF User Manual
Hide thumbs
Also See for Room Divider Medium 3 CF:
Table of Contents
Advertisement
Troubleshooting
6 6
Troubleshooting
6.1
Troubleshooting table
Problem
The pilot light does not come
on after three attempts.
The burner does not operate
within 10 seconds of firing the
pilot light.
When the burner starts you
hear a 'boom' sound.
You hear a loud noise when the
overpressure door (= glass
front) and overpressure hatch
opens.
You hear a continuous beep for
five seconds.
The appliance does not start.
The battery status of the re-
mote control is empty
The appliance does not re-
spond to the remote control.
The appliance regularly stops
for no reason.
The glass is broken or cracked
The lacquer of the appliance is
damaged
6.2
Troubleshooting procedures
6.2.1
Replace the batteries of the remote control
24
Possible cause
One of the cables is disconnec-
ted.
The gas supply is off.
The batteries of the remote
control are empty.
The batteries of the remote
control are empty.
The system has a failure.
There is no power supply (230
VAC).
Caution:
•
Only replace the batteries when the appliance is off.
•
If you put the batteries in an incorrect position, this can cause damage to
the electrical connections.
•
Do not use rechargeable batteries.
Note:
We recommend the use of alkaline batteries.
Possible solution
•
Close the gas supply
•
Contact your fitter.
Contact to your fitter.
Open the gas supply.
Replace the batteries of the re-
mote control. Refer to section
6.2.1
.
On the receiver, push the reset
button.
Repair the power supply.
Contact your fitter.
Replace the glass. For disposal
of the glass refer to
3.3
.
Contact your fitter.
Room divider Medium 3
Advertisement
Table of Contents
