Assigning And Opening Virtual Server Ports - D-Link DCS-1110 User Manual

Section 3 - Configuration

3. Assigning and Opening Virtual Server Ports

The Virtual Server Ports of your router must be opened
for remote access to your camera.This is also referred
to as port forwarding. The D-Link DI-624 is used as an
example to clarify the configuration process. Please
proceed as follows:
• Select Enabled to enable virtual server settings.
• Select a camera name.
• Enter your camera's Local IP Address in the Private
IP field. (Example: 192.168.0.100)
• Select TCP under Protocol Type.
• If you are using the default camera port settings, enter
83 in to the Public and Private Port section.
• Schedule should be set to Always so that the
camera images can be accessed at any time.
• In the Virtual Servers List, a check mark appearing before the camera name will indicate that the ports are
enabled.
• Click Apply to save your settings. Note: If you are installing multiple cameras, be sure to open ONE Web port per
additional camera installed: port 81, 82, etc. for Web server. The AV Control Port and AV Streaming Port also need
to be open. These ports are 5000 and 5001. Each camera will also require different control and streaming ports
(5002, 5003,...etc).
D-Link DCS-1110 User Manual 42