Assigning And Opening Virtual Server Ports; Open Virtual Server Ports To Enable Remote Image Viewing - D-Link SECURICAM Network DCS-950 User Manual

DCS-950 User's Manual

Assigning and Opening Virtual Server Ports

4) Open Virtual Server Ports To Enable Remote Image Viewing

The Virtual Server Ports of your router must be opened for remote access to your
camera. This is also referred to as port forwarding. Please proceed as follows:
• Select Enabled to enable virtual server settings.
• Select a camera name.
• Enter your camera's Local IP Address in the Private IP field.
• Select TCP under Protocol Type.
• If you are using the default camera port settings, enter 80 in to the Public and
Private Port section.
• Schedule should be set to Always so that the camera images can be accessed
at any time.
• In the Virtual Servers List, a check mark appearing before the camera name will
indicate that the ports are enabled.
• Click Apply to save your settings. Note: If you are installing multiple cameras, be
sure to open ONE Web port per additional camera installed: port 81, 82, etc. for
Web server. The AV Control Port and AV Streaming Port also need to be open.
These ports are 5000 and 5001. Each camera will also require different control
and streaming ports (5002, 5003,...etc).
D-Link Systems, Inc.
Installing the DCS-950 Behind a Router
47