Hardware Overview; Connections - D-Link DCS-1110 User Manual

Section 1 - Product Overview
Ethernet Cable Connector
The DCS-1110 features an RJ-45 connector for connections to
10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling.
The port supports 802.3af Power over Ethernet (PoE) and the NWay
protocol, allowing the DCS-1110 to automatically detect or negotiate
the transmission speed of the network. The port also supports MDI/X,
which allows the use of either straight through or cross-over cables.
D-Link DCS-1110 User Manual

Hardware Overview

Reset Button
Reset will be initiated when the reset button is pressed once and Power LED begins to
flash. Factory Reset will be initiated when the reset button is pressed continuously for
ten seconds. Release the reset button and the Power LED will begin to flash indicating
that the DCS-1110's settings are reverting back to the factory settings. The IP address
will also return to the default settings with DHCP selected.

Connections

DC Power Connector
The DC power input connector is labeled
DC 5V with a single jack socket to supply
power to the DCS-1110.The power supply
is optional if PoE is used.
8