Table of Contents
Advertisement
DCS-660 User's Manual
Record Snapshots to your FTP server with
Motion Detection
Administrators can combine options on the application page to perform many useful security tasks. There
are two trigger sources available: from an external sensor or with built-in motion detection. There are also
two kinds of actions that can respond to these events that include uploading snapshots over the internet
and driving attached devices. To upload the snapshots, users can choose either e-mail or FTP according
to user's needs. Both e-mail and FTP use the network settings on the network page. This section describes
how to enable motion detection and record snapshots to an FTP server.
If no external sensor is available, administrators can utilize the built-in motion detection to monitor any
abnormal movement and then record the snapshots to an FTP or SMTP server.
Click the Motion Detection button under the Advanced tab from the Configuration screen to access
settings that affect how the DCS-6620 PTZ Internet Camera can serve as a security device by recording
only when motion is detected.
In this window, follow the steps below to ensure that motion detection is correctly enabled:
Check "Enable motion detection."
Click on "New" to have a new window to monitor video.
Enter in a window name.
Adjust the "Sensitivity" and "Percentage" levels according to the local
environment. The highest sensitivity and lowest percentage provides the most
sensitive setting.
Click on save to enable the activity display.
D-Link Systems, Inc.
Record Snapshots to your FTP server with Motion Detection
Click Motion Detection
63
Advertisement
Table of Contents
