Stationary Pto; Pto Shaft Cover And Shaft Cap - Kubota L2501 Operator's Manual

BStationary PTO
To park the tractor and use the PTO system (for chipper
or pump, for example), start the PTO system in the
following steps.
1. Apply the parking brakes and place blocks at the tires.
2. Make sure the shift levers are at NEUTRAL, and start
the engine.
3. Set the PTO gear shift lever to engage "ON".
4. Set the engine speed to provide recommended PTO
speed.
5. Dismount the seat and tilt up quickly (engine will stop
if there is a delay in tilting up the seat).
[Manual Transmission Type]
[HST Type]
(1) Seat
(2) PTO gear shift lever
A If the PTO system is engaged and you stand up from
the seat or the seat is not tilted forward, the engine
stops automatically after standing up.
"ON"
"OFF"
BPTO Shaft Cover and Shaft Cap
Keep the PTO shaft cover in place at all times.
Replace the PTO shaft cap when the shaft is not in use.
When connecting or disconnecting the joint to PTO shaft,
raise up the PTO shaft cover.
(1) PTO shaft cover (A) "NORMAL POSITION"
(2) PTO shaft cap (B) "RAISED POSITION"
A The universal joint of the PTO drive shaft is technically
limited in its moving angle. Refer to the PTO Drive
Shaft Instructions for proper use.
PTO 35