Every 200 Hours; Replacing Transmission Oil Filter [Hst Type] - Kubota L2501 Operator's Manual

C Direction for Storage
1. When storing the tractor for long periods of time,
remove the battery from tractor, adjust the electrolyte
to the proper level and store in a dry place out of direct
sunlight.
2. The battery self-discharges while it is stored.
Recharge it once every 3 months in hot seasons and
once every 6 months in cold seasons.

EVERY 200 HOURS

BReplacing Transmission Oil Filter [HST
Type]
To avoid personal injury or death:
A Be sure to stop the engine before changing the
oil filter cartridge.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Place the oil pan underneath the transmission oil filter
and remove the filter.
Do not remove the hydraulic oil filter. Otherwise, the oil
comes out.
(1) Transmission oil filter [HST Type]
2. Put a film of clean transmission oil on the rubber seal
of the new filter.
3. Quickly tighten the filter until it contacts the mounting
surface, then, with a filter wrench, tighten it an
additional 1 turn only.
4. After the new filter has been replaced, fill with the
transmission oil up to the upper line of the gauge.
(1) Gauge (A) Oil level is acceptable within this range.
(1) Oil inlet
5. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
6. Make sure that the transmission fluid doesn't leak past
the seal on the filter.
A To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
PERIODIC SERVICE 63