Table of Contents
Advertisement
Connecting the Throttle Cable
1. Place throttle control lever in the fast position (Fig. 5).
2. Hook wire Z–bend into hole of speed control lever
(Fig. 5).
3. Loosen cable clamp screw allowing cable installation,
but do not tighten (Fig. 5).
4. Move control cable casing and wire until hole in speed
control lever is aligned with hole in base plate. Insert a
1/4 in. (6 mm) diameter pin or bolt into aligned holes to
hold adjustment.
5. Pull throttle cable slightly to remove any slack and
tighten cable clamp screw to lock adjustment in place.
6. Remove alignment pin and check control operation.
5
3
4
Figure 5
1. Wire Z-bend
2. Speed control lever
3. Base plate
Installing the Blade Control
(PTO) Rod
1. From outer side of bell crank, insert end of blade
control (PTO) rod thru hole (Fig. 6).
1
2
m–2596
4. Alignment holes 1/4 in.
(6 mm)
5. Cable clamp
15
2
Figure 6
1. Blade control (PTO) rod
2. Bell crank
2. Secure the blade control (PTO) rod to the bell crank
with a hairpin cotter (Fig. 6).
Installing the Control Rods
1. Install the control rod to the drive lever and neutral lock
with a clevis pin and washer (Fig. 7). Washer to be
positioned between drive lever and neutral lock.
2. Install a hairpin cotter between drive lever and washer
and into clevis pin (Fig. 7).
Note: Make sure the clevis pin is inserted into the neutral
lock.
3. Repeat this procedure for the opposite side.
1
3
m–5997
3. Hairpin cotter
Advertisement
Table of Contents
