D-Link DWR-961 User Manual page 9

Section 4 - Configuration
Username: The username provided by your ISP for your PPPoE account.
Password: Password provided by your ISP for your PPPoE account.
Verify Password: Re-type your password in this field.
Service Name: Fill in if provided by your ISP. (Optional)
IP Address: Fill in if provided by your ISP. If not, keep the default value.
Primary DNS Fill in if provided by your ISP. If not, keep the default value
Server: (optional).
Secondary DNS Fill in if provided by your ISP. If not, keep the default value
Server: (optional).
MAC Address: The default MAC address is set to the WAN port's physical interface
MAC address on the router. It is not recommended that you
change the default MAC address unless required by your ISP. You
can use the Clone button to replace the WAN port's MAC address
with the MAC address of your PC.
Maximum Idle The amount of time of inactivity before disconnecting an
Time: established PPPoE session. Set it to zero or enable auto-reconnect
to disable this feature.
MTU: You may need to change the Maximum Transmission Unit (MTU)
for optimal performance. The default value is 0.
Choose Always-on when you want to establish PPTP connection
Reconnect
all the time. If you choose Connect-on-demand, the device will
Mode:
establish a PPTP connection when local users want to connect
to the Internet, and disconnect if there is no traffic after the time
period defined by the Maximum Idle Time setting.
D-Link DWR-961 User Manual
PPPoE (Username / Password)
11