Table of Contents
Advertisement
Regulators and valves
• Use only special vehicle regulators that have a safety valve.
In accordance with the German DVWG (German Associa-
tion of the Gas and Water Sector) Worksheet G 607, other
regulators are not permitted; they are not adequate for
handling the heavy strain.
• Pressure governors must have a fixed pressure of 30 mbar.
The regulations of EN 12864, Appendix D apply accor-
dingly. The pressure governors must have a minimum flow
rate of 1.2 hx/h.
• Attach the high-pressure hose on the bottle carefully by
hand (note: left-handed thread). Do not use spanners,
pliers or similar tools.
• If the temperature is below 5°C use the de-frosting facility
*
(ice-ex
) for regulators.
2
Gas regulator for France and Great Britain
Due to specific country regulations, the gas regulator in
vehicles exported to France and Great Britain is mounted on
the wall of the gas bottle container. The requires the use of a
high-pressure hose. Therefore, the low-pressure hoses that
are normally used may not be fitted here.
- gas regulator mounted on the wall
k
- high-pressure hose
This must be taken into account should it be necessary to
replace the hose.
Connections on gas pressure regulators are screwed on
counterclockwise.
Gas
09-2
1
*
j
Advertisement
Table of Contents
