Table of Contents
Advertisement
• Only accumulator batteries with bound electrolytes (gel
batteries) may be installed in those positions specified
by the manufacturer.
• The installed gel battery may not be opened.
• When changing ancillary batteries, use only batteries
of the same make and capacity.
• All of the electrical devices must be switched off be-
fore you disconnect or connect the ancillary battery.
• Before replacing fuses you must first de-energise the
charger.
• Before replacing fuses you must first de-energise the
charge controller.
• Before replacing a blown fuse you must first fix whate-
ver caused the fuse to blow.
• Fuses may only be replaced by fuses with the same
fuse protection value.
• Airing the charge controller insufficiently will cause a
reduction of the charge current.
• The surface of the charger casing may become hot
when the device is in operation.
Position of the battery circuit breaker
In the Renault, the battery circuit breaker is located in the B-
pillar in the passenger door (see illustration above).
Fiat Drive
directly on the passenger seat.
A circuit breaker has been installed to protect the modular
battery from being exhaustively discharged when the motor
home is not being used. When the switch is opened, the mo-
dular battery is completed disconnected from the 12 V mains.
"Off" position = disconnected from 12V mains.
Electrical Installations
07-28
Advertisement
Table of Contents
