Installing An Internal Sd Card; Removing The Internal Dual Sd Module - Dell DL4300 Owner's Manual

Appliance
Hide thumbs Also See for DL4300:
Table of Contents

Advertisement

Related Links
Safety instructions
After working inside your system
Before working inside your system

Installing an internal SD card

Prerequisites
1.
Follow the safety guidelines listed in Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: To use an SD card with your system, ensure that the Internal SD Card Port is enabled in the
System Setup.
Steps
1.
Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and
insert the contact-pin end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2.
Press the card into the card slot 1 to lock it into place.
Next steps
Related Links
Safety instructions
Before working inside your system

Removing the internal dual SD module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1.
Follow the safety guidelines listed in Safety instructions section.
2.
Follow the procedure listed in the Before working inside your system section.
Steps
1.
Locate the internal dual SD module on the system board.
2.
If installed, remove the SD card.
3.
Hold the plastic pull tab and pull the dual SD module out of the chassis.
123

Advertisement

Table of Contents
loading

Table of Contents