Integrated Storage Controller Card - Dell DL4300 Owner's Manual

2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the cooling shroud.
4. Remove the PCIe card holder.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1. Align the cable retention bracket with the alignment pins on the chassis.
2. Slide the cable retention bracket along the chassis wall until the tab clicks and locks the keyhole
slots.
3. Place all cables to be routed in the cable retention bracket.
Figure 40. Installing the cable retention bracket
1. alignment pin (2)
3. tab
Next steps
1. Install the PCIe card holder.
2. Install the cooling shroud.
3. Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
After working inside your system

Integrated storage controller card

Your system includes a dedicated expansion card slot on the system board for an integrated controller
card. The integrated storage controller card provides the integrated storage subsystem for the internal
hard drives in your system. The controller enables you to set up the hard drives in RAID configurations.
The RAID configurations depend on the version of the storage controller included with your system.
100
2. keyhole slot
4. cable retention bracket