Inserting/Exchanging Gobos - Future light PLS-5R User Manual

Procedure:
Step 1: Unscrew the fixation screws A and B of the lamp system and carefully remove the lamp system
from the housing.
Step 2: If replacing the lamp, remove the old lamp from the lamp holder. Grip the lamp at the ceramic
base and turn the lamp carefully anti-clockwise until the lamp loosens. Remove the lamp from the
lampholder.
Step 3: Carefully insert the new lamp into the lamp holder. Turn the lamp clockwise into the correct
position. There is only one correct lamp position. Please make sure that the new lamp is in the
same position than the old lamp before closing the device.
Step 4: Replace the lamp system in the housing and tighten the fixation screws.
Step 5: Reset the operating hours of the lamp in order to remove the flashing lamp warning in the display
(see chapter Control Board).
Attention: Please note, the MSD Platinum 5R lamp is not a hot-restrike type. You must wait
approximately 15 minutes before you can attempt to strike the lamp once it has been turned off!

Inserting/Exchanging gobos

If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Do not operate this device with opened cover!
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
40/60 00062923, Version 1.0