Function; Information - Future light PLS-5R User Manual

Function

DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
• Select "DMX address" by pressing Up or Down.
• Press the Enter-button, adjust the DMX address by pressing Up or Down.
• Press the Enter-button to confirm.
• Press the Mode/Esc-button in order return to the main menu.
Display the DMX 512 value of each channel
With this function you can display the DMX 512 value of each channel. The display automatically shows the
channel with a value changing.
Slave setting
With this function, you can define the device as slave. You can choose one of three different Slave
programs. For further information see „Edit Program" - „Select Program".
Auto program
With this function, you can run the internal program. You can select the desired program under "Select
program". You can set the number of steps under "Edit program". You can edit the individual scenes under
"Edit scenes". With this function, you can run the individual scenes either automatically, i.e. with the adjusted
Step-Time. The selection "Alone" means Stand Alone-mode and "Master" that the device is defined as
master.
Music control
With this function, you can run the internal program sound-controlled. The selection "Alone" means Stand
Alone-mode and "Master" that the device is defined as master.

Information

Time information
Current time
With this function, you can display the temporary running time of the device from the last power on. The
display shows "XXXX", "X" stands for the number of hours. The counter is reset after turning the device off.
Total run time
With this function, you can display the running time of the device. The display shows "XXXX", "X" stands for
the number of hours.
Last run time - individual fixture running time
This function allows the operator to record the operating hours of the device, according to his requirements.
You can use the counter to document the operating hours since the last service, for example, or to document
the operating hours from a rental. Individual operating hours can be reset at any time. The display shows
"XXXX"; "X" stands for the number of hours.
Lamp hours
With this function, you can display the running time of the lamp. The display shows "XXXX", "X" stands for
the number of hours.
Operating hours since lamp off
With this function, you can monitor the number of minutes during which the device was operated since the
last lamp shutoff or without ignited lamp. The display shows "XXXX", "X" stands for number of minutes. The
counter starts when switching off the lamp.
Last run password
Use this function to enter the password to clear the individual fixture running time. The passwort is „180".
Clear individual fixture running time
With this function you can clear the individual running time of the device (last run time). Please enter the
password under "Last run pass" first.
• Select "Clean last run" the appropriate arrow button.
52/60 00062923, Version 1.0