Quick guide to the Mini Crosser X1 Cabin Introduction Congratulations on your new Mini Crosser X1 Cabin electric mobility scooter. You have now taken possession of an electric mobility scooter developed for outdoor driving by active users. It is what is called a Class C vehicle in according to the European standard EN 12184.
Medema Production A/S Control panel Avoid subjecting the control panel to jarring and knocks. Take care when driving and avoid hitting obstacles. Battery indicator Hazard warning lights Light switch Speed selector Handbrake Indicator lights, R/L Indicator lights, Accelerator (four-finger control) Horn Horn Lever for adjusting the angle of the handlebars...
Page 6
Medema Production A/S Air channel Windscreen wiper + washer Fresh-air/hot-air switch Heat regulation Accelerator (four-finger control) Accelerator (four-finger control) The accelerator forward and backwards are physically connected, which means that when one or the other is activated, the other will move the opposite way.
Page 7
Medema Production A/S Designation Description Key switch To start the vehicle: Turn the key to driving position (1) When the Mini Crosser is turned on, the control system performs a safety check of the electrical system. The check lasts half a second. If the accelerator is operated during this time, the Mini Crosser will not be able to move until you have turned the key to 0 and back to 1.
Medema Production A/S Designation Description windscreen Spraying washer fluid on the front window. washer Fresh-air/hot-air Switch to toggle between heated and unheated air. switch Heat regulation Adjustable heat in the cabin. Note: Heat can be turned on even if the key is not in the key switch.
Medema Production A/S IMPORTANT! The Mini Crosser is most stable when the seat is in its lowest position. Therefore, drive carefully when the seat is up. Never use a seat lift when driving on uneven ground or in hilly landscape. Take extra care when lowering the seat on a Mini Crosser using electric seat adjustment.
Medema Production A/S Charging The Mini Crosser should be charged while not in use. The charger supplied from the factory switches to trickle charging (very low power consumption) automatically when the batteries are fully charged. You can therefore leave the charger connected until the Mini Crosser is next used. The charger cannot overcharge the batteries.
Medema Production A/S Battery indicator If there is an electronic fault, a number of lamps in the battery indicator will light up. The following table shows what they mean. For further information on troubleshooting see the User Manual. Lamps Causes Remedy 1 lamp The batteries need charging or the...
Medema Production A/S Serial number All vehicles have a serial number plate showing the year of production, month and serial number. The same serial number can also be found on the front of the User Manual. Please quote the serial number when making inquiries about servicing, spare parts, etc.
Medema Production A/S Heater Display for: - adjusting the temperature - remove fault code. - turn heater on/off Indicator light for on/off and fault code readout. For more information: see Eberspäcker’s user guide. IMPORTANT! The heating ribs by the window and by the legs should NOT be covered up when the heating is on.
Medema Production A/S Windscreen wiper / washer Start the windscreen wiper by turning this knob. Notice the smooth speed ajusting. Windscreen wiper - turn the knob. Washer - press this button The Container for washer fluid is placed under the front cover. The container for the washer fluid.
In general the following method should be followed: • Make sure that the Mini Crosser X1 Cabin is off (switch turned to 0) when getting in and out, otherwise the Mini Crosser could start if the accelerator was touched inadvertently.
Page 16
Medema Production A/S General safety advice: • Make sure that the backrest is upright and the seat is as low as possible. • Positioning belts are recommended if the user is unable to maintain a good driving posture independently. • Adjust your driving to road conditions.
Medema Production A/S When driving in traffic... Be particularly aware of the following when driving in traffic: • The Mini Crosser is a low vehicle and not always easy for other road users to see. Make quite sure that other road users have seen you before driving onto the highway.
Medema Production A/S Braking systems There are four braking systems on the Mini Crosser: • Motor brake - adjusts vehicle speed also when going downhill. • Magnetic brake - the magnetic brake is automatic and engages when the Mini Crosser stops. In an emergency, the Mini Crosser can be stopped instantaneously by turning the key switch.
Need help?
Do you have a question about the Mini Crosser X1 Cabin and is the answer not in the manual?
Questions and answers