Canopy Assembly - Ellington E-DL60DMI5CRW Installation Manual

6. Wiring. (cont.)
NOTE: Observe "CAUTION" on previous page.
When downrod is secured in place on the hanging
bracket, WIRE THE RECEIVER with wire connectors
provided as shown in diagram 1.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into hanging
bracket.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire connectors into
outlet box. Let antenna rest outside of hanging
bracket.
IN ORDER TO WIRE WALL CONTROL, remove existing
wall switch. Wire the WALL CONTROL with wire
connectors provided as shown in diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push taped
wire connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control. Factory
setting is pre-set and not recommended for use. Write
down number sequence for use in Section 10.
NOTE: Since this fan comes with candelabra base
bulbs, the dimmer switch (labeled D and X) has been
pre-set to the "ON" position (D). If you do not wish to
have dimming capability, please move the switch to
the "OFF" position (X).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided with the wall
control.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of of
the hanging bracket. Partially loosen the other
screw. Lift canopy to hanging bracket. Place
rounded part of slotted hole in canopy over
loosened screw in hanging bracket and push up.
Twist canopy to lock. Re-insert screw that was
removed, and then tighten both screws securely.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
white supply wire
black supply wire
blue
orange
white
black
from fan
from receiver
black
white
orange
blue
diagram 1
(wiring for receiver)
outlet box
diagram 2
(wiring for wall control)
receiver
canopy
page 6
ground (green
or bare)
ground (green
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
wall
control
green/
green/ green/
bare
bare bare
ground
ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
hanging bracket
antenna
or bare)
white
plate
code
switches
dimmer
switch