Display Unit Setup - ACU-RITE 01301CCDI Instruction Manual

Display Unit Setup

1 Set the A-B-C Switch
Locate the A-B-C switch inside the
battery compartment. Set the A-B-C
switch to A, B or C. You must select
the same letter choices for both the
display unit and the sensor in order
for the units to synchronize.
3
Plug in
Power
Adapter
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fre,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
2 Install or Replace Batteries
1. Remove the battery
2. Insert 6 x AA alkaline batteries
3. Replace the battery cover.
3
Plug Power Adapter into
Electric Outlet
Install Batteries
2
6 AA Batteries
(optional)
IMPORTANT: Batteries are a backup power source
to preserve records in the event of a power outage.
Power adapter is recommended as the primary power
source to enjoy the full functionality of this product.
7
compartment cover.
into the battery compartment,
as shown. Follow the polarity
(+/-) diagram in the battery
compartment.
1
A-B-C Switch
set to match sensor
A B C