Display Unit Setup; Acurite Connect - ACU-RITE 02064C Instruction Manual

Display Unit Setup

1 Set the A-B-C Switch
The A-B-C switch is located inside
the battery compartment. It can
be set to A, B or C. However,
you must select the same letter
choices for both the sensor and
the display unit in order for the
units to synchronize.
2 Plug Power Adapter into
Electric Outlet
1
A-B-C Switch
set to match
sensor
A B C
2
Plug in Power
Adapter
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to
be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of
used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries
in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT
recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
3
Write Down the MAC ADDRESS
12 digit unique ID needed for
online connectivity functions.
24 C8 6E
4
Install or Replace Backup
Batteries (optional)
Insert 3 x AA alkaline batteries
into the battery compartment,
as shown. Follow the polarity
(+/-) diagram in the battery
compartment.
3
Write Down
MAC ADDRESS
4
Install Backup
12 digit number
Batteries
3 AA Batteries
IMPORTANT: Batteries are a backup
power source to preserve records
in the event of a power outage.
Power adapter is the recommended
primary power source to enjoy the full
functionality of this product.
8

AcuRite Connect

AcuRite Connect works with Windows PC's to provide access to your Weather
Center data in the following ways:
• Data File: Display unit logs (or stores) data so that you can download it to a
PC in a data file (CSV, or comma-separated values file).
• Web Browser or Smartphone: Monitor sensor data remotely using AcuRite's
free AcuRite online software, or from a mobile device using the free AcuRite
app, available from the iOS App Store or Google Play Store.
Download the Software
The AcuRite Connect software is available online as a free download. A
manual (PDF) is included with the software download.
1
Download AcuRite Connect software to your computer by visiting:
http://www.acurite.com/kbase/downloads/
Or, navigate to the link above using the following path:
www.acurite.com > Support > Downloads
2
Click the .exe file that was downloaded in step 1, and follow the on-screen
instructions to install the software. A folder named "AcuRite Weather
Station" will be installed on the computer.
3
After AcuRite Connect is installed on the computer, open the AcuRite
Connect app. Verify that the display unit is ON
with the power adapter plugged in. Next,
connect the mini-USB
(small end of the cable)
into the USB port on the
display, located inside the
battery compartment.
Connect the USB (larger end of the cable) into a USB port on a Windows
computer.
4
AcuRite Connect is installed and ready for use.
Follow the instructions within
the AcuRite Connect app to
complete setup and begin using
the software.
(PC)
9