Advance; Bridge Setting - Planet ADE-3410v4 User Manual

The following table describes the parameters and buttons of this page:
Field
Direction Select
WAN Setting
WAN Interface
IP Address
Services Allowed
Add
Reset

3.6 Advance

In the navigation bar, click Advance. In the Advance page that is displayed contains
Bridge Setting, Routing, QoS, SNMP and Others.

3.6.1 Bridge Setting

Choose Advance > Bridge Setting, the page shown in the following figure appears. This
page is used to configure the bridge parameters. You can change the settings or view
some information on the bridge and its attached ports.
The following table describes the parameters and button of this page:
Field
Aging Time
802.1d Spanning Tree
Show MACs
Description
Select the router interface. You can select LAN or WAN.
In this example, WAN is selected.
You can choose Interface or IP Address.
Choose the interface that permits data packets from
WAN to access the router.
Enter the IP address on the WAN. Only the IP address
that is in the same network segment with the IP address
on the WAN can access the router.
You can choose the following services from WAN: web,
telnet, ftp, tftp, snmp, or ping. You can also choose all
the services.
After setting the parameters, click it to add an entry to
the Current ACL Table.
Click it to refresh this page.
Description
If the host is idle for 300 seconds (default
value), its entry is deleted from the bridge table.
You can select Disabled or Enabled.
Select Enabled to provide path redundancy
while preventing undesirable loops in your
network.
Click it to show a list of the learned MAC
addresses for the bridge.
62