Hcf Separation Roll Shaft Assembly Removal - Lexmark W850n Service Manual

4024-110

HCF separation roll shaft assembly removal

1.
Remove the HCF media tray assembly. See
2.
Remove the HCF media feed unit assembly. See
page 4-132.
3.
Remove the HCF feed lift motor. See
4.
Remove the HCF feed lift gear bracket. See
5.
Remove the HCF separation roll assembly. See
page 4-145.
6.
Remove the four screws securing the separation roll shaft assembly (A) to the media feed unit assembly
(B).
7.
Remove the separation roll shaft assembly (A).
Note: The HCF media feed unit assembly (B) becomes detached from the separation roll shaft assembly
(A) at the hinge point.
Note: Before re-installing the separation roll shaft assembly (A), ensure the HCF media feed unit assembly (B)
is re-attached at the two hinge points.
4-144
Options Service Manual
"HCF media tray assembly removal" on page
"HCF media feed unit assembly removal" on
"HCF feed lift motor removal" on page
"HCF feed lift gear bracket removal" on page
"HCF separation roll assembly removal" on
B
A
4-127.
4-132.
4-133.