Table of Contents
Advertisement
CONTROL MODULE & COMPONENT MOUNTING
DO NOT Mount the control unit in the engine compartment or where the control unit or wiring harness
where they can become entangled with moving parts such as brake/gas/clutch pedals, or the steering
column! The alarm control module should be mounted in a concealed location. The Placement of the
module will affect the distance from which the remote transmitter can control the unit. The antenna wire
should be routed away from any metal if possible. Do not alter the length of the antenna wire or route it with
other wires. Do not ground the antenna wire. Fasten the module to a bracket or wire harness using the cable
ties provided. Under dash Mounting: If you are locating the control unit underdash, mount it as high as
possible, not easily located by an intruder. Driver's Side Under dash mounting provides an easy location for
wiring most of the system's connections, however this is a common location for an intruder to check for an
alarm after breaking into the vehicle.
WIRELESS SIREN / HOOD: Mount the siren under the hood to an inner fender-well, wheel-well, or other body
surface with the open end facing downward. Run the red siren wire to constant +12V. Ground the black to
the body metal near the siren or you can use one of the siren's mounting screws for a ground. The white wire
connects to "-" hook pin switch.
LED: Mount the red LED in a visible location on the dashboard or console.
WIRELESS TRUNK: Mount inside the trunk close to the trunk light connector, so that it is easy to find the wire
for installation. NOTE: Do not mount the wireless trunk piece on any metal surface. It can be tied to any
harness to hold it. (SEE PAGE 13 FOR INSTALLATION)
Shock Sensor: Mount the included shock sensor with wire ties to an under dash wire harness or fasten with
screws to firewall or side paneling. Use the adjustment screw to set the sensitivity of the sensor. One screw
adjusts both
Valet/Programming Button: Mount the Valet/Override/Program push-button in a hidden but accessible
location. It is REQUIRED for emergency disarm, programming features and entering valet mode.
WIRING
GRAY WIRE: (-) AUX REMOTE OUTPUT 1 (Optional, may require a relay) (300mA)
Connect to the Negative trunk release circuit or to the activation circuit of an auxiliary module or device. If the
circuit requires +12V, then a relay is required. RELAY WIRING: Connect the purple wire to terminal 85,
connect relay terminals 86 and 87 to +12V constant power. Connect terminal 30 of the relay to the +12V
positive device/circuit to be activated.
3
Advertisement
Table of Contents
