Table of Contents
Advertisement
5.3.1
Installation
Dome Cameras Installation
The Response Dome Camera is only suitable for internal use and should not be installed
outside. It is also recommended to install the cables for the dome camera in the ceiling and
passed down the wall through a cable conduit.
Mounting Holes
3
Drill 2 x 5mm holes for the mounting bracket's ceiling plugs and 1 x 20mm hole for
the camera's video and power plugs to pass through the ceiling.
4. Once the cable hole and mounting holes have been made in the ceiling, feed the
connectors of the extension cables through the ceiling, the largest one first. The
camera is supplied fitted with a short piece of cable terminated with a video BNC
female plug and a female power plug. Connect the male end of the video BNC
plug and male power plug from the extension cable into the camera end. Push the
cables into the ceiling before mounting the base.
Fig. 1.
1. Unscrew the rim part of the dome cover
from its base as shown below. Once the
cover is removed, take care not to touch
any of the exposed electronic circuitry to
avoid any possible damage to the
camera (Fig. 1).
2. Use the base of the camera to mark out
the key hole mounting holes and the
cable connector's hole on the ceiling.
Fig. 2.
10
Cable connectors
entry hole position
in ceiling
Advertisement
Table of Contents
