Screen; Border]; Auto Sequence] - Response CWK5 Installation And Operating Instructions Manual

4 camera wired coloured cctv kit

Table of Contents

[MOTION AREA]

Note: To start Motion Record, the user must complete the "Motion Area" setup.

Use this option to select the

Use the DVR's front panel buttons or mouse click to assign the area.

The front panel and mouse control instructions are below.

[Using the

front panel buttons]

Press [SEL] once to pitch on the area, press [SEL] twice to cancel the area.

CH1 - Up / CH2 - Down / CH3 - Left / CH4 – Right

[Using the mouse

Click and hold the left mouse button and move to select, deselect or reselect the motion

detection area for recording.

The area can only be selected from up to down and from left to right. When the block

is covered by blue shadow, it's active to record. When the block is transparent, it can't

be recorded.

After completing the motion area setting, press the [MENU] button or right click the mouse

button to exit.

6.4

Screen

Fig. 6.11

range of motion detection area.

button]

The user can make the white borderline

around each channel to appear or disappear

by using this option to be "on" or "off"

(Fig. 6.11).

6.4.2

This is used to set the time for auto-

matically switching between each of the

camera viewing channels.

Value at "Off, 1 ~ 10 (in seconds)".

Default at "Off".

Table of Contents