NordicTrack REFLEX SR User Manual page 8

3. Insert the excess wire into the right Upright (43)
as you set the console assembly on the
Uprights. Be careful not to pinch any wires.
Attach the console assembly with four 3/8" x
1 1/4" Bolts (2) and four 3/8" Star Washers (4).
Start all four Bolts before tightening any of
them.
4. Locate the Latch Assembly (88). Remove the
knob from the pin. Make sure that the collar and
the spring are on the pin. (Note: If there are two
collars, place one on each side of the spring.)
Next, insert the pin into the Latch Housing (89).
Then, tighten the knob onto the pin.
3
4
2
4
2
4
88
Knob
89
8
Console
Assembly
4
2
4
2
43
Spring
Collar
Pin