NordicTrack REFLEX SR User Manual page 10

If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 1/2" Screws (44)
from the Accessory Cover (122) on the back of
the console assembly.
2. Next, hold the receiver so that the antenna is
oriented as shown. Peel the paper backing off
the pad on the bottom of the receiver. Press the
receiver onto the Accessory Cover (122) in the
location shown.
3. Connect the wire on the receiver to the wire ex-
tending from the console assembly. Make sure
that no wires are pinched. Reattach the
Accessory Cover (122) to the console assembly
with the two #8 x 1/2" Screws (44). Discard the
other wires included with the receiver.
1
122
44
2
Antenna
3
Console
Assembly
10
Console
Assembly
Receiver
122
Wires
122
44