Table of Contents
Advertisement
Chapter 3 Basic Operations — Switching on/off the projector
Switching off the projector
3)
1)
Press the power <v/b> button.
f The [POWER OFF(STANDBY)] confirmation screen is displayed.
2)
Press qw to select [OK], and press the <ENTER> button.
(Or press the power <v/b> button again.)
f Projection of the image stops.
3)
Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> of the projector body lights/
flashes in red.
4)
Press the <OFF> side of the <MAIN POWER> switch to turn off the power.
Note
f Even when the power <v/b> button is pressed and the power is switched off, the projector consumes power if the main power of
the projector is on.
When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], the power consumption during standby can be conserved.
f The power can be turned off by pressing the <OFF> side of the <MAIN POWER> switch while projecting or by directly using the breaker
under conditions where the <MAIN POWER> switch of the projector cannot be switched off/on easily such as while mounting on the ceiling.
However, the settings or adjustments performed right before the power is turned off may not be reflected.
38 - ENGLISH
4)
1)
2)
1)
2)
Advertisement
Chapters
Table of Contents
