Connecting; Before Connecting - Panasonic PT-RZ475EA Operating Instructions Manual

Connecting

Before connecting

f Before connecting, carefully read the operating instructions for the external device to be connected.
f Turn off the power of all devices before connecting cables.
f Take note of the following points before connecting the cables. Failure to do so may result in malfunctions.
g When connecting a cable to a device connected to the projector or the projector itself, touch any nearby metallic objects to eliminate static
electricity from your body before performing work.
g Do not use unnecessarily long cables to connect to a device connected to the projector or to the projector body. The longer the cable, the
more it is susceptible to noise. Since using a cable while it is wound makes it act like an antenna, it is more susceptible to noise.
g When connecting cables, connect GND first, then insert the connecting terminal of the connecting device in a straight manner.
f Acquire any connection cable necessary to connect the external device to the system that is either not supplied with the device or not
available as an option.
f If video signals from AV equipment contain too much jitter, the images on the screen may randomly wobble or waver. In this case, a time
base corrector (TBC) must be connected.
f The projector accepts video signals, analog RGB signals (synchronous signals are TTL level), and digital signals.
f Some computer models are not compatible with the projector.
f Use a cable compensator when you connect devices to the projector using long cables. Otherwise the image may not display properly.
f Refer to "List of compatible signals" (x page 133) for the types of video signals that can be used with the projector.
<COMPUTER IN> terminal pin assignments and signal names
Outside view
(11) (15)
(6)
(10)
(1) (5)
<DVI-I IN> terminal pin assignments and signal names
Outside view
(16) (24) (17)
(8) (1)
C4 C3
C2 C1
C5
30 - ENGLISH
Chapter 2 Getting Started — Connecting
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Pin No.
(1)
(2)
(3) T.M.D.S data 2/4 shield
(4)
(5)
(9)
(6)
(7)
(8)
(9)
(10)
(11) T.M.D.S data 1/3 shield
(12)
(13)
(14)
(15)
Signal name Pin No.
R/P
R
G/Y
B/P
B
―
GND
GND
GND
GND
Signal name Pin No.
T.M.D.S data 2-
T.M.D.S data 2+
―
―
DDC clock
DDC data
Analog VD
T.M.D.S data 1-
T.M.D.S data 1+
―
―
+5 V
GND
Signal name
(9) ―
(10) GND
(11) GND
(12) DDC data
(13) SYNC/HD
(14) VD
(15) DDC clock
Signal name
(16) Hot plug detection
(17) T.M.D.S data 0-
(18) T.M.D.S data 0+
(19) T.M.D.S data 0/5 shield
(20) ―
(21) ―
(22) T.M.D.S clock shield
(23) T.M.D.S clock+
(24) T.M.D.S clock-
C1 Analog R/P
C2 Analog G/G SYNC/Y
C3 Analog B/P
C4 Analog HD/SYNC
C5 Analog GND
R
B