Problems
3D function is not working.
Left and right images are
reversed (not showing
properly).
Image in the 3D eyewear
flickers.
3D eyewear is not
functioning.
Attention
f If problems persist even after checking the preceding points, consult your dealer.
Chapter 5 Maintenance — Troubleshooting
f Are the [3D INPUT FORMAT] and [3D MODE] settings of [3D SETTINGS] correct?
f Check the 3D eyewear settings.
f Is a 3D signal which is supported by the projector being input?
f Is the [LIGHT POWER] setting in [ECO MANAGEMENT] set to [ECO2]?
f Are the devices synchronized? Check the 3D eyewear settings.
f Change the [LEFT/RIGHT SWAP] setting of [3D SETTINGS].
f Are you within the reception range? Are there any obstructions between the 3D
eyewear and the IR transmitter? (when using VESA standard 3D eyewear)
f Are batteries of the 3D eyewear drained? If you use the rechargeable 3D eyewear,
charge it. If you use the battery-powered 3D eyewear, replace the battery.
f Is the IR transmitter connected properly? (when using VESA standard 3D eyewear)
f Turn off the projector and turn it on again. (when using VESA standard 3D eyewear)
f Is the [3D MODE] setting of [3D SETTINGS] correct?
Points to be checked
Page
66
―
135
79
―
66
―
―
―
―
66
ENGLISH - 125