Salus ST620ROF Instruction Manual page 15

ONE TOUCH OVERIDE INTERFACE AND CONTROLS
1 Selecting the set back temperature
On the Side of the One Touch Override (OTO) you
will see a vertical slide switch. The slide switch
allows you to select an override temperature that
will operate when the OTO is activated. If you select
2 º C, 4 º C or 6 º C then the active temperature
selected on the RT500 programmable room
thermostat will be reduced by either 2 º C, 4 º C or 6 º C.
If you select AUTO then the ST620 will switch to the
lowest temperature selected on the ST620.
2. Activating the OTO On the front cover of the One
Touch Override (OTO) you will see that there is a
large button, press this to activate the OTO. When
activated the red light behind the word "OUT" will
flash.
To deactivate the OTO press the button again, the
light will flash once and go out.
Out Button
Key/Operation
OUT
OUT Switches the override feature on or off
SYNC
SETBACK
AUTO
ST620ROF INSTRUCTION MANUAL
SYNC button
Setback
Auto
Functions
Puts the OTO into pairing mode
to allow wireless (RF) connection
Allows selection of a 2°C, 4°C
or 6 °C setback temperature setting
Lowest set temperature in the
ST620 is used (or manual override
setpoint, or programme setting of
that day)
15