Industry Compliance; Important Notes - Crestron infiNET CLW-SLVS1RF Installation Manual

Physical view of CLW-SW4RF/-SWS4RF
(clockwise from top; Top, Side, and Front)
1.75 in
(4.45 cm)
2.38 in
(6.03 cm)
3.81 in
(9.68 cm)
3.28 in
(8.32 cm)
RUN SET OFF
Physical view of CLW-SLVS1RF (clockwise from top; Top,
Side, and Front)
1.75 in
(4.45 cm)
3.81 in
(9.68 cm)
3.28 in
(8.32 cm)
(10.48 cm)
These devices mount in a standard wallbox and are
covered using a decorative faceplate (not included).

Industry Compliance

This product is Listed to applicable UL Standards and
requirements by Underwriters Laboratories Inc.
Installation Guide - DOC. 6293A
1.88 in
(4.77 cm)
2.70 in
4.13 in
(6.86 cm)
(10.48 cm)
1.50 in
(3.81 cm)
1.88 in
(4.77 cm)
2.70 in
4.13 in
(6.86 cm
1.50 in
(3.81 cm)
E239013
infiNET™ Wall Box Switch: CLW-SW1/4RF, SWS1/4RF, & SLVS1RF • 3
infiNET™ SWITCHES
FCC ID: EROCWD1011
Compliance Statement (Part 15.19 )
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
RF Exposure (OET Bulletin 65)
To comply with FCC's RF exposure limits for general
population / uncontrolled exposure, this transmitter must
be installed to provide a separation distance of at least 20
cm from all persons and must not be co-located or
operating in conjunction with any other antenna or
transmitter.
Industry Canada Statement
The term "IC" before the certification/registration number
only signifies that the Industry Canada technical
specifications were met.
IC: 5683A-CWD1011

Important Notes

Read before installation.
•
Codes: Install in accordance with all local and
national electrical codes.
• CAUTION
: TO REDUCE THE RISK OF
OVERHEATING AND POSSIBLE DAMAGE
TO OTHER EQUIPMENT, DO NOT INSTALL
TO CONTROL A RECEPTACLE.
•
Wiring: Use copper wire only. For supply
connection, use wires rated for at least 75°C.
•
Load Type: The -SW1RF, -SW4RF, -SWS1RF,
-SWS4RF, and -SLVS1RF are designed for use
with permanently installed incandescent,
fluorescent (non-dimmable), low voltage,
neon/cold cathode, HID, ceiling fan, or tungsten
halogen lighting.
•
Temperature: The -SW1RF, -SW4RF,
-SWS1RF, -SWS4RF, and -SLVS1RF are
designed to be used where temperatures are
between 32° to 104°F (0° to 40°C).