Table Of Contents; Controller Hardware - HydroPoint WeatherTRAK ET Pro3 2-Wire Getting Started Manual

TABLE OF CONTENTS

Controller Hardware
Controller Board Design
Activation
Navigation
Valve Test
Programming
WeatherTRAK Mobile
WeatherTRAK Mobile can be used to:
• Run manual irrigation
• Change % adjust
• Change controller mode: on/off/shutdown/winterize
• Pause controller
• See active alerts
• Unlock controller
© 2019 HydroPoint Data Systems, Inc. All rights reserved.
3
4
5
5
5
6 - 9
3
WeatherTRAK ET Pro3 2-Wire Installation Instructions
Getting to Know the WeatherTRAK
ET Pro3 2-Wire Controller
In this section, controller navigation and new hardware features
are identified.

Controller Hardware

The WeatherTRAK ET Pro3 2-wire controller delivers unique
hardware features to simplify installation, field diagnostics and
troubleshooting:
• Easily removable command module.
• Interchangeable transformer and ground lug location
• Modular station hardware keys to increase or decrease
station count.
Removable Command Module
The command module can be easily removed or slid down
into a lower position by loosening the captive screws by hand.
Removing the command module (shown in Figure 1) provides
access to the rain switch input and 24 VAC source. If panel
removal is necessary, support it with one hand, then disconnect
the cables with the other hand and set it aside carefully.
Removable Command Module
Figure 1
800.362.8774 • hydropoint.com