Related Manuals for HydroPoint WeatherTRAK ET Pro3 2-Wire
Summary of Contents for HydroPoint WeatherTRAK ET Pro3 2-Wire
- Page 1 GETTING STARTED GUIDE Activate your WeatherTRAK ET Pro3 Controller: at www.weathertrak.com/activate or call (800) 362-8774...
- Page 2 In no event shall HydroPoint Data Systems, Inc., be liable or in any way responsible, for any damages or defects in the product which were caused by repairs or attempted repairs performed by anyone other than HydroPoint Data Systems, Inc.
-
Page 3: Table Of Contents
In this section, controller navigation and new hardware features are identified. Controller Board Design Controller Hardware Activation The WeatherTRAK ET Pro3 2-wire controller delivers unique hardware features to simplify installation, field diagnostics and troubleshooting: Navigation • Easily removable command module. -
Page 4: Controller Board Design
24 VAC Put for Wireless Rain Sensor (red) Rain Switch Input Ribbon Cable Connector 24 VAC MV1 MV2 MV3 MV4 VC VC VC VC FL1 FL2 FL3 FL4 800.362.8774 • hydropoint.com © 2019 HydroPoint Data Systems, Inc. All rights reserved. -
Page 5: Activation
Pressing and holding the button in some limited sub-menus within the SETUP, STATIONS, FLOW and MANUAL menus will display additional information. In the COPY menu the button executes the “copy” function. 800.362.8774 • hydropoint.com © 2019 HydroPoint Data Systems, Inc. All rights reserved. -
Page 6: Programming
Max Backup ET: Represents the worst-case weekly ET for your area for the month of July. If you are not sure what this number should be, call our Customer Service 800 number for help. 800.362.8774 • hydropoint.com © 2019 HydroPoint Data Systems, Inc. All rights reserved. - Page 7 Next Station: Press the right arrow button to go to the next station or use COPY to duplicate settings to like stations. 800.362.8774 • hydropoint.com © 2019 HydroPoint Data Systems, Inc. All rights reserved.
- Page 8 During a rain pause, all irrigation start times will be suspended unless the Usable Rainfall station setting is set to None. While paused, station depletions are held constant. 800.362.8774 • hydropoint.com © 2019 HydroPoint Data Systems, Inc. All rights reserved.
- Page 9 This test cannot be run if any valve is operating. The controller will identify a (SH) “Short” (current draw exceeding 1000 mA) or (NC) “No Connect” reflecting a broken wire. 800.362.8774 • hydropoint.com © 2019 HydroPoint Data Systems, Inc. All rights reserved.
- Page 10 1 (800) 362-8774 support@hydropoint.com WT_ ET Pro3 2-Wire Getting Started Guide RevA 20190412...
Need help?
Do you have a question about the WeatherTRAK ET Pro3 2-Wire and is the answer not in the manual?
Questions and answers