Warranty - Hamax HAM490020 User Manual

EN
User Manual Baby Insert
This manual is additional to the Hamax Multifunctional Child Carrier user manual. Please read the instructions carefully before
assembling or using the baby insert. We wish you and your children many enjoyable trips!
REMARK: Please see the main user manual of the Hamax Child Carrier for details. Should you no longer have the main
manual, this can be downloaded from www.hamax.com
SPECIFICATIONS
• Max weight child: 10kg / 22lb
• Max child height: 75cm / 2.46ft
This baby insert fits all Hamax child carriers.
SAFETY GUIDELINES
WARNINGS
!
• IMPORTANT – READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
• This product is used only in combination with a Hamax child carrier. Other usage can cause serious
injury. Don´t use the baby insert in cars.
• Check the main user manual of your Hamax child carrier for general warnings regarding safe use
of this product.
• This baby insert can only be used for strolling and jogging. Do not use for cycling.
• Avoid serious injury from falling or sliding out. Always use the restraint system.
• Ensure that the baby insert is correctly installed to the child carrier' s frame and seat before use
(as described in these instructions).
• Always adjust the length of the shoulder straps and the crotch strap to securely fit the baby.
• Never leave the child unattended.
• Make sure the suspension is set to the appropriate weight level if adjustable. If your child carrier
does not have suspension, the air pressure of the tires can be reduced to improve damping
behaviour.
• The baby insert is neither a reclining seat, not a carrycot and it is not permitted to use it as such.
• Not recommended for children who can sit upright.
GETTING STARTED - INSTALLATION
For installation video' s please visit www.hamax.com\support
[1] Packaging content & required tools
• Baby insert base (1x) [a]
• Baby insert fabric (1x) [b]
• Fixation strap (2x) [c]
• User manual Hamax Baby Insert (1x)
[2] Preparing the baby insert
• Pull off the fabric cover [b] at the head and feet section of the baby insert to see the fixation holes.
• Guide one of the straps through the holes at the head and the other one through the holes at the feet section of the baby
insert.
• At the feet section you see 4 holes [d] so you can choose the lowest or a bit higher holes to guide the strap through. Only use
the lower set of holes when you want the baby insert to be a bit more upright and have some more leg space.
• Place the baby insert fabric back over the baby insert base again.
[3] Preparing the child carrier
• If your child carrier has the option of reclining the child carrier seat then place the whole seat or only the seat where you want
the baby insert to be to its most reclined position.
p. 1
[4] Installing the baby insert
Top strap (head side of baby insert) [e]
• Place the baby insert on your seat of your choice.
• You can also place 2 baby inserts next to eachother.
• Bring the top fixation strap [e] to the rear side of the child carrier seat. If your child carrier seat has a slot hole [f] in the middle,
guide the fixation strap through that hole to the rear of the child carrier seat. If you don't have this slot seat middle hole, then
guide the strap underneath the harnass straps of the seat [g] next to the baby insert towards the rear of the child carrier seat.
• Now view the child carrier from the rear into the luggage compartment.
• Guide both strap ends around the child carrier frame [h] and close them together with the buckle.
• Make sure the top strap [e] pulls the baby insert downwards enough to be fixed well.
Bottom strap (feet side of baby insert) [i]
• Guide the bottom strap [i] from the front, underneath the child carrier seat, towards the rear of the child carrier.
• In the back of the child carrier, guide the straps around the vertical seat straps [j] of the child carrier seat side where you are
installing the baby insert and close the buckle.
• Tighten both straps well while making sure the baby insert stays positioned correctly.
• Check if the baby insert is fixed well. If the baby insert has too much movement still, fix the baby insert better by pulling the 2
fixation straps tighter.
USE
[5] Using the 5-point safety harness
• Guide the arms through the opening between the shoulder and waist strap. Check that the shoulder straps are aligned with
your child' s shoulders.
• Connect the shoulder strap buckles and insert in the center buckle on the crotch strap.
• Reduce the length of the crotch strap and shoulder straps so that your child is securely tightened. Verify that the safety
harness is locked by pulling on both shoulder straps.
[6] Adjusting the shoulder strap and headrest height
• From the rear of the baby insert turn and guide the shoulder strap end [k] through the holes of the baby insert base and fabric
to the front.
• Remove the headrest [l] from the velcro and keep it connected to the shoulder straps.
• Push the shoulder strap ends through the holes at the desired shoulder height. Make sure it goes through the fabric and the
baby insert base.
• Verify that the strap is securely fastened by pulling on the strap.
.
CARE AND MAINTENANCE
The top layer, shoulder paddings and head rest can be removed from the base seat for cleaning purposes. Wash by hand or use
cold machine wash with a short spin cycle.
[7] Placing the washed fabric [b] onto the baby insert base [a]
• Place the fabric [b] nicely over the baby insert base [a].
• Guide the harnass strap [m] from the rear of the baby insert trough the crotch [n] and waist holes [o] of the baby insert base
and then through the corresponding fabric holes.
• Attach the crotch strap [p] with safety buckle and crotch padding through de harnass crotch buckle [q].
• Place the headrest with shoulder straps [l] on the correct height of the baby' s head. Push the shoulder strap ends [k] through
the holes and rotate them so you can feel they are locked when you pull on the shoulder strap.
• Connect the 2 safety male buckles [r] and insert them into the safety center buckle on the crotch strap.
• Guide the waist harnass strap through the male parts [r] of the safety buckle and then through the shoulder buckle parts [s].

WARRANTY

The Hamax Baby Insert is warranted from the date of purchase. The warranty period depends on the law of the country in
question. The warranty applies to defects in materials or workmanship, and does not cover damage due to improper use, lack
of maintenance, failure to follow the user manual, use of force or normal wear and tear. The warranty is valid for the original
user only. Please read the use and maintenance recommendations carefully. Conditions that may cause premature wear of this
product may not be covered by the warranty. Should this product require service or you want to make a warranty claim, please
contact your local dealer from whom you purchased it.
p. 2