Table of Contents
Advertisement
3.
Loosen the screw at the front of each skid
(2 skids on Guardian decks and 1 skid on
side-discharge decks) as shown in
1. Screw
2. Flange-head bolt
4.
Remove the flange-head bolts and nuts from
each skid.
5.
Move each skid to the desired position and
secure them with the flange-head bolts and nuts.
Note:
Only use the top or center sets of holes
to adjust the skids. The bottom holes are used
when switching sides on a Guardian mower
deck, at which time they become the top holes
on the other side of the mower.
6.
Torque the screw at the front of each skid to 9 to
11 N-m (80 to 100 in-lb).
Adjusting the Rear
Anti-Scalp Rollers
Whenever you change the height-of-cut, adjust the
height of the rear anti-scalp rollers.
1.
Disengage the PTO, move the motion-control
levers to the N
EUTRAL
the parking brake.
2.
Move the throttle lever to the S
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3.
After adjusting the height-of-cut, adjust the
rollers by removing the flange nut, bushing,
spacer, and bolt
Figure
Figure 44
3. Skid
4. Nut
-
position and set
LOCKED
position,
LOW
(Figure
45).
44.
g004479
1. Flange nut
2. Bushing
3. Anti-scalp roller
4.
Select a hole so that the anti-scalp roller
is positioned to the nearest corresponding
height-of-cut desired
1. 38 mm (1-1/2 inches)
2. 51 mm (2 inches)
5.
Install the flange nut, bushing, spacer, and bolt
(Figure
Note:
38
Figure 45
4. Spacer
5. Bolt
(Figure
Figure 46
3. 63 mm (2-1/2 inches)
4. 76 mm (3 inches) and
higher
45).
Torque to 54-61 N-m (40-45 ft-lb).
g004483
46).
g004658
Advertisement
Table of Contents
