Table of Contents
Advertisement
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Pre-Maintenance
Procedures
Important:
The fasteners on the covers of this
machine are designed to remain on the cover
after removal. Loosen all of the fasteners on
each cover a few turns so that the cover is loose
but still attached, then go back and loosen them
until the cover comes free. This prevents you
from accidentally stripping the bolts free of the
retainers.
Figure 60
Service Interval Chart
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be
lubricated regularly with No. 2 general-purpose,
lithium grease. If the machine is operated under
normal conditions, lubricate all bearings and
bushings after every 50 hours of operation. Lubricate
the bearings and bushings daily when operating
conditions are extremely dusty and dirty. Dusty and
dirty operating conditions could cause dirt to get into
the bearings and bushings, resulting in accelerated
wear. Lubricate the grease fittings immediately after
every washing, regardless of interval specified.
1.
Wipe the grease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing.
2.
Pump grease into the fittings.
3.
Wipe off excess grease.
Figure 61
and
grease fittings.
48
Figure 62
illustrate the locations of the
decal125-2747
Advertisement
Table of Contents
