Table of Contents
Advertisement
•
Perform a recovery-regeneration whenever
there is a loss of engine power and a parked
regeneration cannot effectively clean the DPF of
soot.
•
A recovery regeneration requires up to 4 hours
to complete.
•
You need a distributor technician to perform the
recovery regeneration process; contact your
Authorized Toro Distributor.
Adjusting the Height-of-Cut
You can adjust the height-of-cut from 2.5 to 15.8 cm
(1 to 6 inches) in 6 mm (1/4 inch) increments by
relocating the stop pin into different hole locations.
1.
With the engine running, push the deck-lift
switch up until the mower deck is fully raised and
release the switch immediately
2.
To adjust the height-of-cut, rotate the stop pin
until the roll pin in it lines up with the slots in the
holes in the height-of-cut bracket and remove
it
(Figure
43).
3.
Select a hole in the height-of-cut bracket
corresponding to your desired height-of-cut,
insert the pin, and rotate it down to lock it in
place
(Figure
43).
Note:
There are 4 rows of hole positions
43). The top row gives you the height-of-cut
listed above the pin. The second row down gives
you the height listed plus 6 mm (1/4 inch). The
third row down gives you the height listed plus
12 mm (1/2 inch). The bottom row gives you the
height listed plus 18 mm (3/4 inch). For the 15.8
cm (6 inch) position, there is only 1 hole, located
in the second row. This does not add 6 mm (1/4
inch) to the 15.8 cm (6 inch) position.
(Figure
19).
1. Stop pin
4.
(Figure
Adjusting the Skid(s)
Mount the skids in the lower position when operating
in height-of-cuts higher than 64 mm (2-1/2 inches) and
in the higher position when operating in height-of-cuts
lower than 64 mm (2-1/2 inches).
Note:
become worn, you can switch the skid to the opposite
sides of the mower, flipping them over. This allows
you to use the skids longer before replacing them.
1.
2.
37
Figure 43
Adjust the anti-scalp rollers and skids as
required.
On Guardian
®
mowers, when the skids
Disengage the PTO, move the motion-control
levers to the N
-
EUTRAL
the parking brake.
Move the throttle lever to the S
stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
g020870
2. Height-of-cut stop
position, and set
LOCKED
position,
LOW
Advertisement
Table of Contents
