Table of Contents
Advertisement
Releasing the Parking Brake
Push forward and down on the parking-brake lever to
release the parking brake
Figure 15
1. Parking-brake lever
Starting and Stopping the
Engine
Starting the Engine
1.
Raise the roll bar up and lock it into place, sit on
the seat, and fasten the seat belt.
2.
Ensure that the motion controls are in the
N
-
EUTRAL
LOCKED
3.
Set the parking brake; refer to
Parking Brake (page
4.
Move the PTO (power take-off) switch to the
O
position
(Figure
FF
(Figure
15).
position.
Setting the
23).
16).
g020869
1. Ignition switch
2. Throttle control
5.
Turn the ignition key clockwise to the R
position
(Figure
1. Ignition switch
2. Off
6.
After the glow plug indicator light dims, turn the
key to the S
starts release the key.
Important:
more than 15 seconds per minute to avoid
overheating the starter motor.
Note:
Additional starting cycles may be
required when starting the engine for the first
time after the fuel system has been completely
drained.
Important:
the first time, or after an engine oil change,
or an overhaul of the engine, transmission,
or wheel motor, operate the machine with the
throttle lever in the S
24
Figure 16
3. Power take-off (PTO)
switch
17).
Figure 17
3. Run
4. Start
position. When the engine
TART
Use starting cycles of no
When the engine is started for
position in both
LOW
g022121
UN
g004917
Advertisement
Table of Contents
