Table of Contents
Advertisement
Important:
Lower the roll bar only when
absolutely necessary.
1.
To lower the roll bar, remove the hairpin cotters,
push the roll bar forward against the springs,
and remove the 2 pins
1. Roll bar
2. Pin
2.
Lower the roll bar to the down position
13).
1. Pin
2. Roll bar
3.
Install the 2 pins and secure them with the
hairpin cotters
(Figure
Important:
Ensure that the rear part of the
seat is secured with the seat latch.
4.
To raise the roll bar, remove the hairpin cotters
and remove the 2 pins
(Figure
12).
Figure 12
3. Hairpin cotter
Figure 13
3. Mounting hole
12).
(Figure
12).
5.
Raise the roll bar to the upright position and
install the 2 pins and secure them with the
hairpin cotters
Important:
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Operating the Parking
Brake
Always set the parking brake when you stop the
machine or leave it unattended.
Setting the Parking Brake
1.
Move the motion-control levers out to the
N
EUTRAL
2.
Pull up and back on the parking-brake lever to
set the parking brake
Note:
g004639
firmly in the engaged position.
(Figure
1. Parking-brake lever
g004640
The parking brake may not hold the
machine parked on a slope and could
cause personal injury or property
damage.
Do not park the machine on slopes
unless the wheels are chocked or
blocked.
23
(Figure
12).
Always use the seat belt when the
-
position
(Figure
LOCKED
(Figure
The parking-brake lever should stay
Figure 14
WARNING
18).
14).
g020868
Advertisement
Table of Contents
